| 路肩石与路边石的安装要求 |
| 添加时间：2018/8/22 15:48:28 浏览次数： |
| 1.路边石必须挂通线进行施工,按侧平面顶面示高标线绷紧，按线码砌侧平石，侧平石要安正，切忌前仰后合，侧面顶线顺直圆滑平顺，无高低错牙现象，平面无上下错台、内外错牙现象。 1. The roadside stone must be constructed by hanging through the line, indicating the tension of the high standard line on the top surface of the side plane, laying the side flat stone according to the line code, and the side flat stone should be straight, avoiding back and forth, the side top line should be straight and smooth, no high and low teeth, no upper and lower staggered platform, internal and external staggered teeth. 2.路边石必须座浆砌筑，座浆必须密实，严禁塞缝砌筑； 2. the roadside stone must be built in slurry, and the slurry must be dense. 3.路边石接缝处错位不超过1mm；侧石和平石必须在中间均匀错缝。 3. the dislocation of roadside stone joint should not exceed 1mm; side stone and stone must be evenly sewn in the middle. 4.路边石侧平石应保证尺寸和光洁度满足设计要求。外观美观，对弯道部分侧石应按设计半径专门加工弯道石，砌筑时保证线形流畅、圆顺、拼缝紧密。弧形侧石必须人工精凿后抛光处理。 4. roadside side stone should ensure that the size and finish meet the design requirements. Beautiful appearance, the curved part of the side stone should be designed according to the radius of special processing curved stone, masonry to ensure smooth line, smooth, tight joint. The arc side stone must be cleaned after polishing. 5.路边石后背应还土夯实，夯实宽度不小于50mm，厚度不小于15mm。 5. the back of the roadside stone should be compacted with soil. The width of the roadbed is not less than 50mm, and the thickness is not less than 15mm. 6.路边石勾缝：勾缝时必须再挂线，把侧石缝内的杂物剔除干净，用水润湿，然后用1：2.5水泥砂浆灌缝填实勾干 6. Roadside stone joints: when joints must be put on the line again, the side of the stone joints in the debris removal clean, wet with water, and then 1:2.5 cement mortar filling joints dry hook. 7.路边石勾缝、安砌后适当浇水养护。 7. roadside stone pointing, after building, proper watering and maintenance. |
| 上一页 路缘石滑模施工工法 |
| 下一页 路肩石模具保养 |